A client’s AKG 414 stopped giving any signal through his Focusrite Scarlett OctoPre, which feeds his Scarlett 18i20 over ADAT, and the cause was the clock setting on the OctoPre.
He got in touch because his AKG 414 condenser mic had stopped working and he was frustrated with it. The mic goes into a Focusrite Scarlett OctoPre, and the OctoPre connects over ADAT to his Scarlett 18i20. Before he contacted me he had already worked through a good list of checks of his own.
What he had already tried
- Changed the mic cable.
- Moved the mic and tried the other input on the OctoPre.
- Tried a dynamic mic, in case phantom power was the problem. The dynamic mic gave no signal either.
- Pressed the buttons he could see on the front panel (phantom power, instrument and pad). They change the mode of the inputs, but made no difference.
- Plugged the condenser mic straight into the 18i20, bypassing the OctoPre, and it worked.
Because the mic worked when it went straight into the 18i20, he had proved it couldn’t be the mic or the cable. It just seemed that the OctoPre wasn’t being recognised for some reason.
The clock button on the side
Once I connected and looked through his system, the solution was on the right-hand side of the OctoPre.
The OctoPre only works over ADAT when it is either receiving a clock source or generating its own clock.
He had the sync button pressed in, which meant the OctoPre was working in word clock mode, but he had no word clock source going into it. He needed to press the source button again and set the OctoPre to internal, so that it generates its own clock, sends it over ADAT to the 18i20 and keeps the two devices digitally in sync. Once he pressed the internal button on the right-hand side of the OctoPre, the mic came to life and he was able to record it into Logic.
How the setting changed
I don’t think it happened randomly. He told me he had been moving some cables around while sorting out his headphone routing, and it’s quite possible he bumped that button while he was doing it.
If an ADAT preamp goes silent after you’ve been moving cables around near it, its clock setting is one of the first things I’d look at.
Not sure it’s the same problem? Ask a question first
